AstroWiki

User Tools

Site Tools

Trace:
drop_setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
drop_setup [2012/04/06 14:57] – leeuwendrop_setup [2013/10/22 13:49] – leeuwen
Line 7: Line 7:
       * Remove 'old' boot image on master, for this node: **/tftpboot/pxelinux/pxelinux.cfg/C0A800F?** where ? = EDCBA9 for nodes 012345       * Remove 'old' boot image on master, for this node: **/tftpboot/pxelinux/pxelinux.cfg/C0A800F?** where ? = EDCBA9 for nodes 012345
       * Manually reboot node (force PXE boot with F12 if needed)       * Manually reboot node (force PXE boot with F12 if needed)
 +      * Prompts for "language"? Change master root dir permissions: ''chmod a+rx ~root''
   * If network is slow (dmesg | grep eth says "Link is up at 10 Mbps, half duplex") force with ethtool:   * If network is slow (dmesg | grep eth says "Link is up at 10 Mbps, half duplex") force with ethtool:
       * ''/sbin/ethtool -s eth1 speed 1000'' (if fails, set ''/sbin/ethtool -s eth1 autoneg'' off then on)       * ''/sbin/ethtool -s eth1 speed 1000'' (if fails, set ''/sbin/ethtool -s eth1 autoneg'' off then on)
       * for eth0 ''ifdown eth0; ifup eth0''       * for eth0 ''ifdown eth0; ifup eth0''
 +  * Keys: [ctrl-ctrl] = bring up display server screen ; [ctrl-alt-f2/f3/f4] = emergy sh, dmesg, etc.
 DONE DONE
   * ROCKS user guide: http://www.rocksclusters.org/roll-documentation/base/5.1/   * ROCKS user guide: http://www.rocksclusters.org/roll-documentation/base/5.1/
Line 99: Line 100:
    * LIGHTPATH    * LIGHTPATH
      * installed eth2 on c4. edited ''/etc/sysconfig/network-scripts/ifcfg-eth2'' to static ''IPADDR=192.87.39.129'', ''NETMASK=255.255.255.248'', ''MTU=9000''      * installed eth2 on c4. edited ''/etc/sysconfig/network-scripts/ifcfg-eth2'' to static ''IPADDR=192.87.39.129'', ''NETMASK=255.255.255.248'', ''MTU=9000''
-     * On command line, added ''route add 145.100.26.152 gw 192.87.39.130'' for Huygens +     * On command line, added ''/sbin/route add 145.100.26.152 gw 192.87.39.130'' for Huygens 
-     + 
 +2013 BOOT 
 + Kernel 2.6.18-238.9.1.el5 got beyond RAID wait after 5 minutes. 
 +               348.18.    Bad IRQ, kernel panic (as was original problem) 
 +                  .16.    Wait=6min, Bad IRQ  
 +                  .12.    Wait=6min, Bad IRQ  
 +                  .6.     Wait=6min, Bad IRQ  
 +(e)dit, remove quiet                      
 + 
 TODO TODO
   * Read OAK topics and redo   * Read OAK topics and redo
  
  
drop_setup.txt · Last modified: 2013/10/22 14:04 by leeuwen